MarineWorx OnWater Services
MarineWorx OnWater Services are carried out by a team of five staff who have experience covering all of our in-house services. Our goal is to provide the very highest standards of workmanship, matched with a great work ethic.
We welcome your enquiry and look forward to assisting you in maintaining your vessel to meet your full expectations.
- Boat washing and detailing
- Interior cleaning, laundry, oven cleaning, and detailing
- Polishing stainless and rust removal
- Teak cleaning
- Cut, polishing and waxing
- Vessel deliveries
- Window water stain removal
- Rainex window application
- Varnishing
- Water Blasting / Non-skid and mould removal
- Roller painting/ tipping for touchups and repaints
- Fibreglass repairs
- Gelcoat repairs
- Engine room/ bilge cleaning
- Engine repaints
- All plumbing/ toilet repairs or replacement
- Holding tank installations
- General maintenance
- Diver anode replacement and inspections
- 12/24 volt electrical repairs and installations
- Full vessel management
- Security checks
- Project management
- Regular engine/ Genset start up / running
- Refueling service
- Pre use checks and preparation
- Fitting of wharf fenders and corner wheels
The best way to help reduce your maintenance costs and to ensure your vessel is kept to a high standard is to use it and run its equipment on a regular basis. The marine environment is unforgiving on your boat and its equipment.
If you are time short or unable to use your boat then you can book MarineWorx to carry out this work for you. We are able to schedule in the regular running of your vessel to test and operate its onboard equipment. Taking your vessel to sea will see the correct engine operating temperature achieved while helping to reduce the amount of marine growth on your antifouling. Or we can carry out checks of your vessel and operate its onboard equipment while it remains at its berth.
Our vessel and equipment checks include:
- Dock power supply, current Test & Tag and EWOF
- Dock lines and fender settings
- Exterior inspection and security checks
- Bilge inspection and test bilge pumps
- Run the genset under load, pre checks of coolant and oil
- Run engines and engage forward and reverse (approx. 20 min)
- Check and clean sea strainers and check through hull fittings
- Battery condition (and voltage if monitored electronically) (to manually check battery voltage the batteries need to be rested for approx 4 hours)
- Flush toilets
- Run refrigeration
- Safety equipment checks (date of flares, EPIRB and liferaft)
- Exercise all seacocks
- Contact you should any matters need attention
- Text advise after the inspection has been carried out
- Fill out hard copy of inspection and leave onboard
Or simply fill out the contact form below: